ST-7610HP Resistance to Hot Particle Tester

ST-7610HP Resistance to Hot Particle Tester Standards: According to clause 7.1 of BS EN50396-2005, BS638-4, IEC60695-2-11 standards etc. Range: It used to determine flammability, ignition temperature and fire fatalness for products, which include lighting, low voltage electronic appliances, household appliances, electric tools and instruments. It is also applied to plastics and insulation materials, electric connectors etc. Technical Parameters: 1.Needle Burner: I/D Ø0.5mm ± 0.1mm, O/D≤Φ 0.9mm, and length ≥ 35mm made of stainless steel; 2.Angle of burner: 20~90o can be adjusted to vertical or incline can be adjust to flame to the contact point between the heated rod and test sample. 3.Burning gas: Butane or propane, the purity is 95% (prepare by customer) 4.Test sample: according to demand to prepare by customer. 5.Flame temperature: Heating rising from 100 ± 2°C to 700 ± 3°C within 23.5±1.0s; 6.Temperature sensor: K-type thermocouple and the diameter is Φ 0.5mm, the max temperature is 1100°C; 7.Flame height: 12mm ± 1mm, can be adjust 8.Burning time: 0 ~ 999.9s can be setting and LCD display 9.Heating Rod: Diameter is 2.5±0.05mm, Length is 100±0.5mm, made of 18/8 chrome-nickel steel. 10.Test current: 0~30A/AC can be adjust and pre-set (for heat the rod keeping the temperature at 300°C) 11.Test voltage: 0.01~1000V/AC(r. m. s) and control by program 12.Display: LCD display with 2 lines of content. 13.Test force: 1.2N 14.Power supply: 220V/AC, 50Hz, can be design as customer’s request